Corrosion-resistant stainless steel straps securely hold extinguisher in place. Finger tabs allow quick access.
Model C16-0448-062, Cat. SA7010BPCN. EZ Plug. No rewiring – adapter included. Replaces most 120VAC alarms. Photoelectric sensor stops most false alarms. Battery backup during power outages. Mutes unwanted alarms. Eco-friendly.
Feature:
Sensitivity/Alarm Time:
Within 60~90 minutes at 50ppm CO concentration;
Within 10~40 minutes at 100ppm CO concentration;
Within 3 minutes at 300ppm CO concentration
LCD Displayer (optional): 4 digits LCD displayer
Audibility: 85dB ( at 1m distance ), Frequency 3 – 0.5KHZ
Standby Current: <50μA
Alarm Current: <50mA
Standby Mode: Green Led flashes once every 30 seconds
Alarm Mode : Red Led quickly flashes 4 times with unit chirping every 5 seconds, then repeat,
Low-bat Indicator:Chirp every 30s as battery lower than 3.3V with green LED flashing and Lb on LCD
Mal-function Indicator:
Chirp every 30s with green LED out and Err on LCD
Power consumption: 0.3mW
Size: 10 x 4cm
Powered By: 2x AA Batteries (Not included)
A perfect item for protecting your family from the dangers of carbon monoxide
Advanced level of protection, easy to read with the digital display, even in low light conditions
Displays the level of carbon monoxide the unit is sensing
Green LED: Flashes every 30 seconds to indicate the unit is operating properly. The green LED will also flash before CO reading is taken and when any button is pressed.
Red LED : When a dangerous level of carbon monoxide is detected the red LED will pulse and a loud alarm pattern will sound. The carbon monoxide alarm pattern is 4 short beeps, followed by 5 seconds of silence, followed by 4 short beeps with a corresponding red LED flash. This cycle will continue for 4 minutes and then change to 1 cycle every minute until the device is reset or the CO is eliminated.
Test/Reset button is designed for weekly testing if it works properly
and reset the unit during CO alarm
Alerts users when batteries needs to be replaced
This alarm is highly recommended to be mounted on a wall surface
Compact, lightweight & easy to operate
The First Alert 7010B Hardwired Smoke Alarm with Battery Backup and photoelectric sensor is designed to meet new building code while reducing common ‘nuisance’ alarms. This makes it an excellent choice for installation in kitchens, near fireplaces, or in hallways outside bathrooms, utility rooms, and other areas prone to steam that may accidentally set off other alarms. The Photoelectric sensor featured in this smoke alarm is more efficient in detecting slow and smoldering fires which smolder for hours before bursting into flame. This alarm also has Optipath 360 technology which provides 360 degrees of direct access to the smoke sensor. The single test/silence button silences a non-threatening alarm or low battery warning and allows you to test the unit’s functionality. This smoke detector also comes with a locking feature for tamper resistance which makes it a great choice for hotel/motel application.